Advanced Extrusion - Troubleshooting

Advanced Extrusion - General Thermoforming & Cutting

General Thermoforming and Cutting Troubleshooting Guide

Poor Detail
Too Much or unwanted Detail
Webbing or bridging
Distorted geometry or warped parts
Dents or wrinkles in parts
Poor material distribution
Plug Marks
Thin spots in Parts
Surface of Parts is dimpled
Chill Spots
Hot Spots
Inconsistent forming process
Blowing Holes
Thick bottom
Thin Bottom

Standard Thermoforming Equipment Overview

There are three standard configurations for thermoforming equipment:

1) Heat and Cut-in-Place Forming

2) In-Line Forming with Steel Rule or Forged Steel Trim wand Air Pressure and/or Plug Assist

3) Two Station Forming with Air Pressure and/or Plug Assist and Secondary Matched Metal or Forged Steel Trim

The data herein represents typical or average values by the test methods or formulas indicated. Processing and other variables are a major factor in product performance; this information should serve only as a guide. No warranty is made or implied. The corporation assumes no obligation or liability for the use of data presented.

Phone:	Fax:	Address:	Email:
763-262-4480	763-262-4488	14300 Liberty Lane Becker, MN 55308	info@advancedextrusion.com